15341 Autoloader ALE: Error: request to rotate plate when rotator not properly installed Trendsetter_400/800_Auto Remove the plate from the machine and select "PLATE CLEARED" button on the workstation dialog box. Call Creo Service. The system wants to rotate the plate currently on the unload table, but the rotator is not installed in firmware. Check the rotator_installed parameter (set al ri) and the rotate_plate parameter for the plate on the unload table (set state plate_loc u rp). If plates are to be rotated, set the 'al ri' (rotator installed) parameter to 1 and save the value (nvs save al ri). If plates are not to be rotated, set the bay rotate_plate parameter to 0 (set state bay 1 rp 0). Any plates picked from the bay will now be set up to not be rotated. It may be useful to set the 'verbose alcmd' and 'verbose alconv 'parameters to 1 in order to obtain further diagnostic information. The rotate_plate parameter may be set to 1 with the rotator_installed parameter still at 0. ../commands/process.xmlCommand: process ../commands/clear.xmlCommand: clear Command: set state bay 1 Command: set state plate_loc u ../nvs/al_cfg_ri.xmlNVS: al ri ../nvs/bay_state_rp.xmlNVS: bay rp ../nvs/plate_loc_state_rp.xmlNVS: plate_loc rp ../nvs/verbose_cfg_alcmd.xmlNVS: verbose alcmd ../nvs/verbose_cfg_alconv.xmlNVS: verbose alconv ..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:33:03 2008 PST